[
点击图片查看原图
德国aircom详细说明
描述:
Pressure regulator R6:
Design as R7 but for bottom-sided flange assembly via fittings
and o-rings made of NBR/Buna-N. Mounting through four screws (M3)
with extremely small screw heads.
Pressure regulator RP:
This model guards against unauthorised tampering of pressure.
Alternatively available with preset pressure. The pressure is to
be set between 30 mbar and 2.8 bar. Its headroom is reduced to 49 mm.
Diverter block M5000:
M3000 features four ports sideways and one on top. All ports can
be provided with threads or blank slides, the ports sideways
optionally with connector slides.
Top_cover:
blank cover (B)
with G1/8 thread (1)
with G1/4 thread (2)
with M5 thread (10-32 UNF) (0)
Connector_slide:
to join two units and without through hole (C)
with through hole (U)
Assembly:
After loosening the bottom screw any placements of threads,
connector and blank slides are possible.
Sealing results from o-rings made of NBR/Buna-N.
Temperature_range: 4 °C to 70 °C / 39.2 °F to 158 °F
Body: glass-fiber reinforced Celcon
Inner_valve: stainless steel and Celcon
Elastomer: NBR/Buna-N
德国aircom型号大全
R280-08EG G1`` 0.5-25bar流量计
AIC-FM-03_02过滤器
AirCom R160-04B13-01
AirCom 过滤器 AIC-FM-03_02
AirCom R160-04B15
AIRCOM R310
AIRCOM RE1
R120-08F减压阀
AirCom R450-04I
PR000-5000比例调节阀
MHA-A2P压力表
AirCom F465-06EL
R450-06I减压阀
AirCom 过滤器 F465-06EL
特价供应 AirCom 调压阀 PR000-1600
AirCom Repairkit for RH3-04D
特价供应 AirCom 调压阀 PT602-0801
FM-03_02过滤器
MHA-A5P压力表
AirCom R039-01CF
德国aircom品牌介绍
德国AirCom公司压力变送器工作原理：当压力直接作用在测量膜片的表面，使膜片产生微小的形变，测量膜片上的高精度电路将这个微小的形变变换成为与压力成正比的高度线性、与激励电压也成正比的电压信号，然后采用专用芯片将这个电压信号转换为工业标准的4-2OmA电流信号或者1-5V电压信号。由于测量膜片采用标准话集成电路，内部包含线性及温度补偿电路，所以可以做到高精度和高稳定性，变送电路采用专用的两线制芯片，可以保证输出两线制4-2OmA电流信号。德国AIRCOM压力变送器主要性能：1、使用被测介质广泛，可测油、水及与316不锈钢和304不锈钢兼容的糊状物，具有 定的防腐能力；2、高准确度、高稳定性、选用进口原装传感器，线性好，温度稳定性高；3、体积小、重量轻、安装、调试、使用方便；4、不锈钢全封闭外壳，防水好；5、压力传感器直接感测被测液位压力，不受介质起泡、沉积的影响。
描述:
Pressure regulator R6:
Design as R7 but for bottom-sided flange assembly via fittings
and o-rings made of NBR/Buna-N. Mounting through four screws (M3)
with extremely small screw heads.
Pressure regulator RP:
This model guards against unauthorised tampering of pressure.
Alternatively available with preset pressure. The pressure is to
be set between 30 mbar and 2.8 bar. Its headroom is reduced to 49 mm.
Diverter block M5000:
M3000 features four ports sideways and one on top. All ports can
be provided with threads or blank slides, the ports sideways
optionally with connector slides.
Top_cover:
blank cover (B)
with G1/8 thread (1)
with G1/4 thread (2)
with M5 thread (10-32 UNF) (0)
Connector_slide:
to join two units and without through hole (C)
with through hole (U)
Assembly:
After loosening the bottom screw any placements of threads,
connector and blank slides are possible.
Sealing results from o-rings made of NBR/Buna-N.
Temperature_range: 4 °C to 70 °C / 39.2 °F to 158 °F
Body: glass-fiber reinforced Celcon
Inner_valve: stainless steel and Celcon
Elastomer: NBR/Buna-N
德国aircom型号大全
R280-08EG G1`` 0.5-25bar流量计
AIC-FM-03_02过滤器
AirCom R160-04B13-01
AirCom 过滤器 AIC-FM-03_02
AirCom R160-04B15
AIRCOM R310
AIRCOM RE1
R120-08F减压阀
AirCom R450-04I
PR000-5000比例调节阀
MHA-A2P压力表
AirCom F465-06EL
R450-06I减压阀
AirCom 过滤器 F465-06EL
特价供应 AirCom 调压阀 PR000-1600
AirCom Repairkit for RH3-04D
特价供应 AirCom 调压阀 PT602-0801
FM-03_02过滤器
MHA-A5P压力表
AirCom R039-01CF
德国aircom品牌介绍
德国AirCom公司压力变送器工作原理：当压力直接作用在测量膜片的表面，使膜片产生微小的形变，测量膜片上的高精度电路将这个微小的形变变换成为与压力成正比的高度线性、与激励电压也成正比的电压信号，然后采用专用芯片将这个电压信号转换为工业标准的4-2OmA电流信号或者1-5V电压信号。由于测量膜片采用标准话集成电路，内部包含线性及温度补偿电路，所以可以做到高精度和高稳定性，变送电路采用专用的两线制芯片，可以保证输出两线制4-2OmA电流信号。德国AIRCOM压力变送器主要性能：1、使用被测介质广泛，可测油、水及与316不锈钢和304不锈钢兼容的糊状物，具有 定的防腐能力；2、高准确度、高稳定性、选用进口原装传感器，线性好，温度稳定性高；3、体积小、重量轻、安装、调试、使用方便；4、不锈钢全封闭外壳，防水好；5、压力传感器直接感测被测液位压力，不受介质起泡、沉积的影响。